Hummer 2004 H2 User Manual download pdf (Page 91)

100

101

The following instructions tell you how to change the

automatic door unlock mode. Choose one of the

four programming options listed above before entering

the program mode. To enter the program mode, do

the following:

1. Begin with the ignition off. Then pull the turn

signal/multifunction lever toward you and hold

it there while you perform the next step.

2. Turn the key to RUN and LOCK twice. Then, with

the key in LOCK, release the turn

signal/multifunction lever. Once you do this, the

doors will lock and unlock, the horn will chirp twice,

and a 30-second timer will begin. You are now

ready to program the automatic door unlock feature.

3. Press the unlock side of the power lock switch once.

You will hear one, two, three, or four chimes. The

number of chimes tells you which unlock mode

is currently selected. Continue to press the

door unlock switch until the number of chimes that

you hear matches the number of the mode that

you want. If you take longer than 30 seconds, the

locks will automatically lock and unlock and the horn

will chirp twice to indicate that you have left the

program mode. If this occurs, you can repeat

the procedure beginning with Step 1 to re-enter the

programming mode.

You can exit the program mode any time by turning the

ignition to RUN (the doors will automatically lock and

unlock and the horn will chirp twice to indicate that you

are leaving the program mode). If the lock/unlock

switches are not pressed while in the programming

mode, the current automatic settings will not be

modiﬁed.

Rear Door Security Locks

With this feature, you can lock the rear doors so they

can’t be opened from the inside by passengers.

This feature is located on

the inside edge of the rear

doors.

2-11

1 2 ... 86 87 88 89 90 91 92 93 94 95 96 ... 471 472

Comments to this Manuals

No comments

Hummer 2004 H2 User Manual Page 91

Comments to this Manuals