Hummer 2004 H2 User Manual Page 124

  • Download
  • Add to my manuals
  • Print
  • Page
    / 472
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 123
6. Locate in the garage, the garage door opener
receiver (motor-head unit). Locate the “Learn”
or “Smart” button. This can usually be found where
the hanging antenna wire is attached to the
motor-head unit.
7. Firmly press and release the “Learn” or “Smart”
button. The name and color of the button may
vary by manufacturer.
You will have 30 seconds to start Step 8.
8. Return to the vehicle. Firmly press and hold the
programmed HomeLink
®
button for two seconds,
then release. Repeat the press/hold/release
sequence a second time, and depending on the
brand of the garage door opener (or other rolling
code device), repeat this sequence a third time
to complete the programming.
HomeLink
®
should now activate your rolling-code
equipped device.
To program the remaining two HomeLink
®
buttons,
begin with Step 2 of “Programming HomeLink
®
.” Do not
repeat Step 1.
Gate Operator and Canadian
Programming
Canadian radio-frequency laws require transmitter
signals to “time out” or quit after several seconds of
transmission. This may not be long enough for
HomeLink
®
to pick up the signal during programming.
Similarly, some U.S. gate operators are manufactured to
“time out” in the same manner.
If you live in Canada, or you are having difficulty
programming a gate operator by using the
“Programming HomeLink
®
procedures (regardless of
where you live), replace Step 3 under “Programming
HomeLink
®
with the following:
Continue to press and hold the HomeLink
®
button while
you press and release every two seconds (cycle) your
hand-held transmitter until the frequency signal has been
successfully accepted by HomeLink
®
. The indicator light
will flash slowly at first and then rapidly. Proceed with
Step 4 under “Programming HomeLink
®
to complete.
Using HomeLink
®
Press and hold the appropriate HomeLink
®
button for at
least half of a second. The indicator light will come
on while the signal is being transmitted.
2-44
Page view 123
1 2 ... 119 120 121 122 123 124 125 126 127 128 129 ... 471 472

Comments to this Manuals

No comments