Hummer 2009 H2 User Manual download pdf (Page 212)

To calibrate the compass, use the following procedure:

Compass Calibration Procedure

1. Before calibrating the compass, make sure the

compass zone is set to the variance zone in

which the vehicle is located. See “Compass

Variance (Zone) Procedure” earlier in this section.

Do not operate any switches such as window,

sunroof, climate controls, seats, etc. during

the calibration procedure.

2. Press the vehicle information button until

PRESS

V TO CALIBRATE COMPAS (Compass)

displays. Or, if the vehicle does not have DIC

buttons, press the trip odometer reset stem until

CALIBRATE COMPASS displays.

3. Press the set/reset button to start the compass

calibration. Or, if the vehicle does not have DIC

buttons, press and hold the trip odometer reset stem

for two seconds to start the compass calibration.

4. The DIC will display CALIBRATING: DRIVE IN

CIRCLES. Drive the vehicle in tight circles at less

than 5 mph (8 km/h) to complete the calibration.

The DIC will display CALIBRATION COMPLETE

for a few seconds when the calibration is complete.

The DIC display will then return to the

previous menu.

DIC Warnings and Messages

Messages are displayed on the DIC to notify the driver

that the status of the vehicle has changed and that

some action may be needed by the driver to correct

the condition. Multiple messages may appear one after

another.

Some messages may not require immediate action, but

you can press any of the DIC buttons on the instrument

panel or the trip odometer reset stem on the instrument

panel cluster to acknowledge that you received the

messages and to clear them from the display.

Some messages cannot be cleared from the DIC

display because they are more urgent. These messages

require action before they can be cleared. You should

take any messages that appear on the display seriously

and remember that clearing the messages will only

make the messages disappear, not correct the problem.

The following are the possible messages that can be

displayed and some information about them.

CHANGE ENGINE OIL SOON

This message displays when the engine oil needs to

be changed. When you change the engine oil, be sure

to reset the CHANGE ENGINE OIL SOON message. See

Engine Oil Life System on page 5-18 for information on

how to reset the message. See Engine Oil on page 5-15

and Scheduled Maintenance on page 6-4 for more

information.

3-56

1 2 ... 207 208 209 210 211 212 213 214 215 216 217 ... 523 524

Comments to this Manuals

No comments

Hummer 2009 H2 User Manual Page 212

Comments to this Manuals

Related products and manuals for Cars Hummer 2009 H2